The respirator ffp3 should be cleaned and disinfected every day. Whether it is a gauze mask or an air filter mask, it can be disinfected by heating. The specific method is:
1. Wash. First, gently rub the gauze mask with warm water and soap. The bowl-shaped mask can be gently cleaned with a soft brush dipped in detergent, and then washed with clean water. Please be careful not to rub it hard, because if the warp and weft gap of the gauze is too large, it will lose the effect of preventing droplets.
2. Disinfection. Soak the cleaned mask in 2% peracetic acid solution for 30 minutes or boil it in boiling water for 20 minutes or steam it in a steamer for 15 minutes, then dry it for later use. This method is suitable for gauze masks and bowl masks.
3. Check. Masks and face coverings should be carefully checked to see if they are still in good condition before being used again. In any case, the respirator ffp3 generally needs to be updated after 3 to 7 times of cleaning, and a particularly good quality mask can be cleaned 10 times.
like：
The function and applicable scenarios of respirator ffp3
What are the applicable occasions of respirator ffp3
What are the precautions for using respirator ffp3
What should I do if the e-cigarette gets water? People often carry e-cigarettes on their bodies, and it is inevitable that they accidentally fall into the water when using them. vape products，So what should we do at this time?
The e-cigarette should be powered off as soon as it enters the water, that is, unplug it. When it is powered off, you must ensure your own safety, wipe your hands dry, or wear insulating gloves to avoid electrical leakage and electric shock.
Then remove the moisture from the e-cigarette. The more timely and quicker this step is, the greater the chance of success. Drying, lifting, etc. can be used to remove moisture.
At this time, there will be moisture in the electronic cigarette, and it needs to be blown dry with a hair dryer. It is recommended to use a hair dryer to heat the small drops of water on the circuit board and grooves to further dry it.
If you are still worried about residual moisture, it is recommended to put the e-cigarette with water in a dry place for a few days, and then you can use it.
The above is the way to deal with the water in the electronic cigarette. It is best to let the after-sales replace you. This is the best method. After all, the water may cause the motherboard to burn out. It is also very troublesome for us to deal with it by ourselves.
like:
What are the hazards of girls smoking e-cigarettes?
There are several types of electronic cigarettes
The principle of infra-red self-heating leg padding: The self-heating joint patches go ahead and take all-natural nutrient tourmaline because the core, and type a complete with nano-biofunctional materials to produce this system. With regards to temperatures and tension modifications, it can continuously release far-infra-red and bad ions. home health care suppliers,And bring the thermoelectric excitement impact of mini-current to the body.
It might efficiently increase blood flow, alleviate muscle tiredness, activate tissue, market metabolic rate, dredge meridians, expel wind and dampness, reduce discomfort and frosty, and increase the body's condition amount of resistance. Triggering endocrine can also alleviate community low energy and ache, lessen damage, and guard bones from injury during workout.
How to use: Put on this product closely for the knee joints of your entire body, along with the knee joints will generate temperature and acupuncture feelings in about a quarter-hour, and the energy can get to the deeply elements of your body. It may be donned for three hours every time, and works extremely well several times per day.
like：
The Benefits of Warming Your Back